Language:DEENFRES
Automatic Positioning System BDG

Baumann BDG

Automatic Positioning Systems provide you with a module which permits automatic cutting. Turning and aligning of the reams on the cutter's rear-table as well as the cut(s) themselves are carried out fully automatically. BDG is suitable both for printed and unprinted sheets. The cutting-process and the BDG are controlled by the cutting program.

  • The following tasks can be automated
  • Turning of the layer by 90° prior to the first cut (while feeding the cutter)
  • Turning of the layer by 90° or 180°
  • 4-side-trim
  • Dividing cuts
  • Cutting strips (the last strip must have a certain minimum dimension)

The cross-section cut as well as all further cuts after the last strip has been cut automatically are carried out manually as part of the cutting program.

The portal design as well as the 3-axis-control provide a dynamic system, which can be adjusted to suit the product.

Possible combinations

  • Combination with a pushing system
  • Combination with an automatic jogger
  • Combination with a gripper transport system BFS / BFS-R

Advantages

  • Most important component for the automatic cutting process
  • Important increase in productivity
  • Relief of the operator's physical strain
  • Combination with numerous functional components
  • Highly dynamic, enabling a very quick turning and aligning process
  • The speed can be adjusted to suit the product